---===SME_1310_00002_0001.djvu===---
chassis 
Supplement 
Pub.No.00ELB0017, SEPTEMBER 2013 
Shop Manual 
( 
EURO V 
) 
2013 Minor Change 
---===SME_1310_00002_0002.djvu===---
---===SME_1310_00002_0003.djvu===---
Pub.No.00ELB0017, SEPTEMBER 2013 
---===SME_1310_00002_0004.djvu===---
GROUP INDEX 
MODIFICATION SUMMARY ............ 
GENERAL ........................................ 
CLUTCH ........................................... 
TRANSMISSION 
<M038: DUONIC> ........................... 
TRANSMISSION <M038> ................ 
DUONIC ........................................... 
PROPELLER SHAFT ....................... 
FRONT AXLE <INDEPENDENT> ... 
REAR AXLE ..................................... 
WHEEL AND TIRE ........................... 
FRONT SUSPENSION 
<INDEPENDENT> ............................ 
REAR SUSPENSION ....................... 
ANTI-LOCK BRAKE 
SYSTEM (ABS) ................................ 
PARKING BRAKE............................ 
STEERING 
<RACK AND PINION> ..................... 
HEATER AND 
AIR CONDITIONER ......................... 
BODY ............................................... 
FOREWORD 
This Shop Manual is published for the information and 
guidance of personnel responsible for maintenance of 
Mitsubishi Fuso ROSA series buses, and includes proce- 
dures for adjustment and maintenance services. We ear- 
nestly look forward to seeing that this manual is made full 
use of in order to perform correct services with no wast- 
age. 
As this Shop Manual is published as a supplement to the 
following Shop Manuals, please refer to the followings for 
information not included in this manual. 
Chassis ROSA BE6. BC6 ........... Pub. No. TWSE0329 
For more details, please consult your nearest authorized 
Mitsubishi Fuso dealer or distributors. 
Kindly note that the specifications and maintenance ser- 
vice figures are subject to change without prior notice in 
line with improvement which will be effected from time to 
time in the future. 
SEPTEMBER 2013 
Applicable models 
BE 
©2013 Mitsubishi Fuso Truck & Bus Corporation Printed in Japan 
---===SME_1310_00002_0005.djvu===---
This Shop Manual contains the information classified into the following groups. 
If any system or equipment has two or more variations with significantly different construction, the variations are 
handled as different groups. These groups are identified by different alphabets preceded by the same number. 
1. ENGINE volume (Pub.No.00ELB0016) 
2. CHASSIS volume (supplement) (Pub.No.00ELB0017) 
3. ELECTRICAL volume (Pub.No.00ELB0018) 
Group No. 
Group subject 
00 
GENERAL 
11 
ENGINE 
12 
LUBRICATION 
13 
FUEL AND ENGINE CONTROL 
13E 
ENGINE CONTROL 
14 
COOLING 
15 
INTAKE AND EXHAUST 
17 
EMISSION CONTROL 
17E 
DPF (Diesel Particulate Filter) SYSTEM 
Group No. 
Group subject 
MODIFICATION SUMMARY 
00 
GENERAL 
21 
CLUTCH 
22A 
TRANSMISSION <M038: DUONIC> 
22B 
TRANSMISSION <M038> 
22E 
DUONIC 
25 
PROPELLER SHAFT 
26B 
FRONT AXLE <INDEPENDENT> 
27 
REAR AXLE 
31 
WHEEL AND TIRE 
33B 
FRONT SUSPENSION <INDEPENDENT> 
34 
REAR SUSPENSION 
35E 
ANTI-LOCK BRAKE SYSTEM (ABS) 
36 
PARKING BRAKE 
37B 
STEERING <RACK AND PINION> 
55 
HEATER AND AIR CONDITIONER 
63 
BODY 
Group No. 
Group subject 
54 
ELECTRICAL 
---===SME_1310_00002_0006.djvu===---
1 
MODIFICATION SUMMARY 
---===SME_1310_00002_0007.djvu===---
2 
This section describes the differences from "Shop Manual chassis ROSA BE6. BC6" (Pub.No.TWSE0329). 
Be sure to check the differences described in the following before servicing. 
Group 
Contents of different points 
Service 
procedure 
HOW 
TO 
READ 
THIS 
MAN- 
UAL 
(1) "HOW TO READ THIS MANUAL" is changed. 
See Gr00. 
00 (1) "MODEL CODING SYSTEM" is different. 
See Gr00. 
(2) "POWER TRAIN TABLE" is different. 
(3) The engine number is different. 
(4) The following are added to "PRECAUTIONS FOR MAINTENANCE OPERATION". 
Handling of Battery 
Precautions When Repainting 
Precautions When Handling a Vehicle with DUONIC System 
Precautions on Cleaning When Servicing the Engine and Transmission 
(5) "JACKING UP THE VEHICLE" is added. 
(6) "DIAGNOSIS CODES" is added. 
(7) "TABLE OF STANDARD TIGHTENING TORQUES" is different. 
21 (1) Clutch is different. 
See Gr21. 
22A, B (1) Transmission is different. 
See Gr22A, B. 
22E (1) DUONIC is added. 
See Gr22E. 
25 (1) Propeller shaft is different. 
See Gr25. 
26B (1) In "STRUCTURE AND OPERATION", Wheel Hub and Rotor, Knuckle is changed. 
See Gr26B. 
(2) "TROUBLESHOOTING" is added. 
(3) In "ON-VEHICLE INSPECTION AND ADJUSTMENT", Inspection of Wheel Bearing for Play is 
added. 
(4) "WHEEL HUB AND ROTOR, KNUCKLE" is changed. 
27 (1) In "STRUCTURE AND OPERATION", Wheel Hub and Brake Drum is changed. 
See Gr27. 
(2) "ON-VEHICLE INSPECTION AND ADJUSTMENT" is added. 
(3) "WHEEL HUB AND BRAKE DRUM" is changed. 
31 (1) "WHEEL AND TIRE" is different. 
See Gr31. 
33B (1) FRONT SUSPENSION <INDEPENDENT TYPE> is different. 
See Gr33B. 
34 (1) REAR SUSPENSION is different. 
See Gr34. 
35A (1) Specifications for Vacuum Pump are different. 
Same as be- 
fore except 
these explained 
here. 
Item 
Specifications 
Type 
Radial blades type 
Output 
cm 
3 
/rev. 
150 
MODIFICATION SUMMARY 
---===SME_1310_00002_0008.djvu===---
3 
35A (2) Vacuum pump is different. 
The vacuum pump (depressor), with radial blades, is also incorporated in the gear of oil pump 
with built-in depressor (GPOD). 
It is driven directly by the oil pump. 
(See Gr11.) 
Same as be- 
fore except 
these explained 
here. 
35E Anti-lock brake system (ABS) is different. 
See Gr35E. 
36 Parking brake is different. 
See Gr36. 
37B (1) Specifications for power steering oil pump are different. 
Same as be- 
fore except 
these explained 
here. 
Group 
Contents of different points 
Service 
procedure 
Item 
Specifications 
Manufacturer 
FIAT POWERTRAIN TECHNOLOGIES 
Type 
Vane type 
Delivery rate 
cm 
3 
{mL}/rev. 
11.5 {11.5} 
Adjusted flow volume 
dm 
3 
{L}/min. 
6to8{6to8} 
Adjusted pressure (relief valve) 
MPa {kgf/cm 
2 
} 
11.0 {112 } 
Permissible revolutions 
rpm 
500 to 4900 
0 
--1 
0 
--10 
---===SME_1310_00002_0009.djvu===---
4 
37B (2) Power steering oil pump is different. 
• The power steering pump incorporated in the engine block generates hydraulic pressure for 
steering assistance. 
The pump is driven by the engine via the timing gear chain. 
• The power steering pump cannot be disassembled. To remove and reinstall it, see Gr11. 
-- 
(3) Power steering system is different. 
-- 
Group 
Contents of different points 
Service 
procedure 
MODIFICATION SUMMARY 
---===SME_1310_00002_0010.djvu===---